Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 4 Series
428User Manual 1335.5337.02 ─ 05
TIMebase:REFerence <RescaleCtrPos>
Sets the position of the reference point in % of the screen. It defines which part of the
waveform is shown.
Parameters:
<RescaleCtrPos> Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
Usage: Asynchronous command
Manual operation: See "Reference point" on page 99
17.8.3
Roll mode
TIMebase:ROLL:ENABle................................................................................................ 428
TIMebase:ROLL:MTIMe..................................................................................................428
ACQuire:ROLLmode:OSCapture..................................................................................... 429
ACQuire:ROLLmode:POINts?......................................................................................... 429
TIMebase:ROLL:STATe?.................................................................................................429
TIMebase:ROLL:ENABle <Mode>
Selects, if the roll mode is set automatically by the instrument or if it is turned off.
Parameters:
<Mode> AUTO | OFF
*RST: AUTO
Usage: Asynchronous command
Manual operation: See "Mode" on page 100
TIMebase:ROLL:MTIMe <MinAcquTime>
Sets the minimum acquisition time for automatic start of the roll mode.
Parameters:
<MinAcquTime> Range: 0.5 to 100000
Increment: 1
*RST: 2
Default unit: s
Usage: Asynchronous command
Manual operation: See "Start roll time" on page 100
Acquisition and setup
Loading ...
Loading ...
Loading ...