Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 4 Series
218User Manual 1335.5337.02 ─ 05
Clock source ← Setup/Hold time measurement
Sets the waveform used as clock in the setup/hold measurement.
Remote command:
MEASurement<mg>:SSRC on page 529
Clock slope ← Setup/Hold time measurement
Sets the edge of the clock from which the setup and hold times are measured: positive,
negative, or either of them. If "Either" is selected, the clock edges next to the data edge
are considered regardless of the clock slope.
Remote command:
MEASurement<mg>:AMPTime:CSLope on page 531
Data source ← Setup/Hold time measurement
Sets the source for the data signal.
Delay measurement
The specific settings for delay measurement allow you to measure the time between
any two slopes at any reference level. Therefore, the reference levels and the slopes
must be defined for each source individually. The measurement result is negative if the
edge of the second source comes before the edge of the first source.
Automatic measurements
Loading ...
Loading ...
Loading ...