Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 4 Series
463User Manual 1335.5337.02 ─ 05
Parameters:
<CutOffFreq> KHZ5 | KHZ50
KHZ5 = 5 kHz
KHZ50 = 50 kHz
*RST: KHZ50
Usage: Asynchronous command
Manual operation: See "Filter, Cut-off" on page 141
TRIGger:ANEDge:CUToff:LOWPass <CutOffFreq>
Frequencies higher than the cut-off frequency are rejected, lower frequencies pass the
filter.
Parameters:
<CutOffFreq> KHZ50 | MHZ50
KHZ50 = 50 kHz
MHZ50 = 50 MHz
*RST: KHZ50
Usage: Asynchronous command
Manual operation: See "Filter, Cut-off" on page 141
TRIGger:ANEDge:NREJect <NoiseReject>
Enables an automatic hysteresis on the trigger level to avoid unwanted trigger events
caused by noise.
Parameters:
<NoiseReject> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Trigger noise reject" on page 141
17.9.4 Glitch trigger
TRIGger:EVENt<ev>:GLITch:POLarity............................................................................. 463
TRIGger:EVENt<ev>:GLITch:RANGe...............................................................................464
TRIGger:EVENt<ev>:GLITch:WIDTh................................................................................464
TRIGger:EVENt<ev>:GLITch:POLarity <Polarity>
Sets the polarity of a pulse, which is the direction of the first pulse slope.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Trigger
Loading ...
Loading ...
Loading ...