Loading ...
Loading ...
Loading ...
Waveform analysis
R&S
®
MXO 4 Series
184User Manual 1335.5337.02 ─ 05
3. Drag the slider to the required acquisition. The current number is shown in the
"Current acq" field.
Alternatively, enter the number of the required acquisition in the "Current acq" field.
To save a single history waveform
1. Select and display the required history waveform as described in "To display a par-
ticular acquisition" on page 183.
2. Save the selected waveform using "Save/Recall" > "Save" tab > "Waveform". For
details, see Chapter 12.2, "Save and recall waveform data", on page 261.
To replay history waveforms
If you want to see the complete acquisition series without any setup, simply tap in the
quick-access "History" dialog box. For specific analysis of history data, use the history
"Viewer" setup.
1. Open the "History" configuration dialog tab.
2. If the history mode is off (the [History] key is not illuminated), enable "Show his-
tory".
3.
Tap
to start.
To exit the history
► Choose one of the following ways:
● Close the quick-access "History" dialog box.
● In the "History" configuration tab, disable "Show history".
● Start the acquisition.
8.4 Reference waveforms
You can configure up to four reference waveforms to display stored waveforms. Any
active signal, mathematical waveform or spectrum can be stored as a reference wave-
form. It can then be loaded again later to restore the waveform on the screen.
8.4.1 Working with reference waveforms
Reference waveforms can be displayed in addition to the signal waveforms.
To display a reference waveform
1. In the "Menu" > "Apps" > "General" tab, select "Reference".
Alternatively, press the [Ref] key.
2. Select the tab for the reference waveform that you want to display ("R1/2/3/4").
Reference waveforms
Loading ...
Loading ...
Loading ...