Loading ...
Loading ...
Loading ...
When the waveform invert is turned off, the waveform is displayed normally; when
the waveform invert is turned on, the voltage values of the displayed waveform are
inverted. Enabling the waveform invert will change the result of math function and
waveform measurement.
Figure 5.1 Waveform Invert
NOTE
When the waveform invert is enabled, the trigger edge or the trigger polarity will change (e.g.
Edge trigger, Pulse trigger, or Slope trigger).
5.10 To Set the Probe
The analog channel of this oscilloscope not only supports the common passive probe,
but also the active probe. It can automatically recognize the currently connected
probe type and its probe ratio. For detailed technical information of the probes,
please refer to the corresponding Probe User Guide.
Press to open the CH1 setting menu. Then, press Probe to open the probe menu.
If different probes are connected to the oscilloscope, different information about the
probe will be displayed, and you can perform the different operations on the menu.
5.10.1 Passive Probe
If a passive probe is connected, for example, when RIGOL RP3500A probe model is
connected to the oscilloscope, press Probe to open the probe menu. Its sub-menus
are grayed out and disabled.
TIP
For some of the ordinary passive probes, the oscilloscope can recognize their probe ratio
automatically. If not recognized, please refer to "
Probe Ratio
" to set the probe ratio.
To Set the Vertical System
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
55
Loading ...
Loading ...
Loading ...