Rigol MSO8154A oscilloscope

Rigol MSO8000A series user guide - Page 318

For MSO8154A.

PDF File Manual, 406 pages, Read Online | Download pdf file

MSO8154A photo
Loading ...
Loading ...
Loading ...
• Set the Amplitude or High Level
First press Amplitude or High Level, then rotate the multifunction knob to
select "Amplitude" or "High Level". You can also press Amplitude or High Level
continuously to select it. Enable the touch screen to select it. Rotate the
multifunction knob or use the pop-up numeric keypad to set the amplitude
or high level of the current signal. Note that if you select "Amplitude" for this
menu, then the menu below Amplitude is automatically turns out to be "Offset";
if you select "High Level" for this menu, then the menu below High Level is
automatically turns out to be "Low Level". When the impedance is set to HighZ,
its range is from 20 mVpp to 5 Vpp; when the impedance is set to 50 Ω, its range
is from 10 mVpp to 2.5 Vpp.
• Set the Offset or Low Level
First press Offset or Low Level, then rotate the multifunction knob to select
"Offset" or "Low Level". You can also press Offset or Low Level continuously to
select it. Enable the touch screen to select it. Rotate the multifunction knob or
use the pop-up numeric keypad to set the offset or low level of the current
signal. When the impedance is HighZ, its range is from (-2.5 V + the current
amplitude/2) to (2.5 V - the current amplitude/2); when the impedance is set to
50 Ω, its range is from (-1.25 V + the current amplitude/2) to 1.25 V - the current
amplitude/2).
• Set the Start Phase
Press Start Phase, then rotate the multifunction knob or use the numeric
keypad to set the start phase of the current signal. Its available range is from 0°
to 360°.
• Align Phase
Pressing Align Phase will re-configure the two channels to output according to
the preset frequency and phase. For two signals whose frequencies are the same
or in multiple relationship, this operation can align their phases. Use the
oscilloscope to acquire the waveforms of the two channels and stably display the
waveforms. After switching the channel status, the phase deviation between the
two waveforms is changed. At this time, press Align Phase, then the phase
deviation shown on the oscilloscope will restore to the current phase deviation
between the two waveforms automatically.
• Set Other Parameters
Press Settings to enter the other parameter setting menu. You can set the
parameters such as modulation, sweep, burst, and impedance.
- Modulation, sweep, and burst
Function/Arbitrary Waveform Generator (Option)
302
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Loading ...
Loading ...
Loading ...