Loading ...
Loading ...
Loading ...
21.1.6 To Output Noise
Press Wave, then use the multifunction knob to select "Noise" and then press
down the knob to select the waveform. You can also press Wave continuously or
enable the touch screen to select it. At this time, you can set the Amplitude/High
Level, Offset/Low Level, and Impedance of the Noise signal.
1. Set the Amplitude or High Level
First press Amplitude or High Level, then rotate the multifunction knob to
select "Amplitude" or "High Level". You can also press Amplitude or High Level
continuously to select it. Enable the touch screen to select it. Rotate the
multifunction knob or use the pop-up numeric keypad to set the amplitude or
high level of the current signal. Note that if you select "Amplitude" for this menu,
then the menu below Amplitude is automatically turns out to be "Offset"; if you
select "High Level" for this menu, then the menu below High Level is automatically
turns out to be "Low Level".
2. Set the Offset or Low Level
First press Offset or Low Level, then rotate the multifunction knob to select
"Offset" or "Low Level". You can also press Offset or Low Level continuously to
select it. Enable the touch screen to select it. Rotate the multifunction knob or
use the pop-up numeric keypad to set the offset or low level of the current signal.
3. Set the Impedance
Press Impedance continuously to set the output impedance of the Function/
Arbitrary Waveform Generator. It can be set to "HighZ" or "50Ω".
21.1.7 Sinc
Press Wave, then use the multifunction knob to select "Sinc" and then press down
the knob to select the waveform. You can also press Wave continuously or enable the
touch screen to select it. At this time, you can set the parameters for the Sinc
waveform (as shown in the figure below). For setting methods, refer to descriptions in
"
To Output Sine
".
Function/Arbitrary Waveform Generator (Option)
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
305
Loading ...
Loading ...
Loading ...