Loading ...
Loading ...
Loading ...
Edge Type:
Press
Slope to select the desired clock edge type. It can be set to "Rising" or
"Falling"
.
Data Source:
Press SDA to set the signal source of the data line. It can be set to CH1-CH4 or D0-
D15. For details, refer to descriptions in "
Trigger Source
". The current data source
(trigger source) is displayed at the upper-right corner of the screen.
NOTE
Only when we select the channel (that has been input with signals) as the trigger source, can
we obtain a stable trigger.
Data Type:
Press Data Type to set the effective pattern of the data signal. It can be set to H (high
level) or L (low level).
Trigger Condition:
Press When, then rotate the multifunction knob to select the of Setup/Hold
trigger condition, and then press down the knob to select it. You can also press
When
continuously or enable the touch screen to select it.
• Setup: the oscilloscope triggers when the setup time is smaller than the
specified setup time. After selecting this type, press Setup, and then rotate the
multifunction knob or use the pop-up numeric keypad to set the setup time.
• Hold: the oscilloscope triggers when the hold time is smaller than the specified
hold time. After selecting this type, press Hold, and then rotate the
multifunction knob or use the pop-up numeric keypad to set the hold time.
• Setup/Hold: the oscilloscope triggers when the setup time or hold time smaller
than the specified time value. After selecting this type, press Setup and Hold
respectively, then rotate the multifunction knob or use the pop-up numeric
keypad to set the setup and hold time.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press to quickly switch
the current trigger mode. For details, refer to descriptions in "
Trigger Mode
".
Trigger Parameter Setting:
To Trigger the Oscilloscope
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
107
Loading ...
Loading ...
Loading ...