Rigol MSO8154A oscilloscope

Rigol MSO8000A series user guide - Page 109

For MSO8154A.

PDF File Manual, 406 pages, Read Online | Download pdf file

MSO8154A photo
Loading ...
Loading ...
Loading ...
• X: sets the pattern of the channel selected to "X", i.g. this channel is not used as
a part of the pattern. When all channels in the pattern are set to "X", the
oscilloscope will not trigger.
•
Rising: sets the pattern to the rising edge (" ") of the channel selected.
•
Falling: sets the pattern to the falling edge (" ") of the channel selected.
At this time, the corresponding pattern is displayed at the bottom of the screen. The
patterns of channels CH1-CH4 and D0-D15 are presented from left to right, as shown
in the figure below.
You can also set the pattern with the virtual keypad. The setting methods are as
follows:
Enable the touch screen to tap the channel pattern. Then, a virtual keypad is
displayed. Set the channel pattern with the keypad. For example, tap CH2 pattern,
then the the channel pattern is displayed, as shown in
Figure 8.6
. Tap the left arrow
key to move the cursor to the left or tap the right arrow key to move the
cursor to the right. Then select a pattern. After the pattern of the current channel is
set completely, the cursor goes to the next pattern bit automatically. Set them
respectively. After all the pattern bits are set completely, tap OK to confirm the
setting, and close the virtual keypad. You can also tap ALL to apply the current pattern
to all the channels. This key functions the same as the All Bits menu key.
Confirmation Key
All Bits
Move the cursor
to the left
Move the cursor
to the right
Pattern
Figure 8.6 Virtual Keypad for Pattern Setting
NOTE
Only one edge (rising or falling edge) can be specified in the pattern. If one edge item is
currently defined and then another edge item is defined in another channel in the pattern,
To Trigger the Oscilloscope
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
93
Loading ...
Loading ...
Loading ...