Loading ...
Loading ...
Loading ...
data, it indicates that the decoded data are not fully displayed. At this time,
you can view the details in the "Packets" view. If you select "Payload", all data
in the specified column will be displayed in the event table. If "…" appears in
the specified column of data, it indicates that the decoded data are not fully
displayed. At this time, you can view the details in the "Packets" view.
- Export: If you select "Packets", you can export time and the corresponding
decoded data. Press Export, then the save setting interface is displayed. You
can export the data table of the packet to the internal memory or the
external USB storage device (when detected) in CSV format. For detailed
saving operation, refer to descriptions in "
Store and Load
".
- Jump to: Set the operating status of the oscilloscope to "STOP". Then, select
the data of the specified time from the event table. Press Jump to and the
specified data waveforms are displayed in the center of the screen.
- Decode: The setting of this menu enables you to quickly view the
corresponding event tables of four decode modules (Decode1, Decode2,
Decode3, and Decode4). Press Decode, then use the multifunction knob
to select a decode module, then press down the knob to select it. You can
also press Decode continuously or enable the touch screen to select it.
6. Address Information in Decoding
For I2C bus, each frame of data starts with the address information (read address
and write address). In the address information, "Read" indicates the read address
( ) and "Write" indicates the write address ( ). You can decide
whether to include or exclude the "R/W" bit for the address information.
Protocol Decoding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
247
Loading ...
Loading ...
Loading ...