Rigol MSO8154A oscilloscope

Rigol MSO8000A series user guide - Page 114

For MSO8154A.

PDF File Manual, 406 pages, Read Online | Download pdf file

MSO8154A photo
Loading ...
Loading ...
Loading ...
Source Selection:
Press Source to open the signal source list and select CH1-CH4 or D0-D15. For
details, refer to descriptions in "
Trigger Source
". The current trigger source is
displayed at the upper-right corner of the screen.
NOTE
Only when we select the channel (that has been input with signals) as the trigger source, can
we obtain a stable trigger Wave.
Edge Type:
Press
Slope, then rotate the multifunction knob to select input signal edge on
which the oscilloscope triggers. You can also press Slope continuously or enable the
touch screen to select it.
• Rising: starts timing when the rising edge of the input signal passes through
the trigger level.
• Falling: starts timing when the falling edge of the input signal passes through
the trigger level.
• Either: starts timing when either edge of the input signal passes through the
trigger level.
Timeout Value:
Timeout value represents the maximum time that the signal remains idle before the
signal passes through the trigger level. Press Timeout, and then rotate the
multifunction knob or use the pop-up numeric keypad to set the timeout value.
The available range is from 16 ns to 10 s.
Trigger Mode:
In the trigger control area (Trigger) on the front panel, press to quickly switch
the current trigger mode. For details, refer to descriptions in "
Trigger Mode
".
Trigger Parameter Setting:
Sets the trigger parameter (noise rejection) under this trigger type. For details, refer
to descriptions in "
Noise Rejection
".
Trigger LEVEL/Threshold Level:
To Trigger the Oscilloscope
98
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Loading ...
Loading ...
Loading ...