Rigol MSO8154A oscilloscope

Rigol MSO8000A series user guide - Page 319

For MSO8154A.

PDF File Manual, 406 pages, Read Online | Download pdf file

MSO8154A photo
Loading ...
Loading ...
Loading ...
For details about modulation, sweep, and burst, refer to descriptions in
"
Modulation
", "
Sweep
", and "
Burst
".
NOTE
When "Pulse", "DC", or "Noise" is selected under
Wave, this menu is not available.
- Set the impedance
Press
Impedance continuously to set the output impedance of the
Function/Arbitrary Waveform Generator. It you can be set to "HighZ" or
"50Ω".
21.1.2 To Output Square
Press Wave, then use the multifunction knob to select "Square" and then press
down the knob to select the waveform. You can also press Wave continuously or
enable the touch screen to select it. At this time, you can set the parameters for the
Square waveform. For setting methods, refer to descriptions in "
To Output Sine
". The
duty cycle of the square waveform is a fixed value 50%.
21.1.3 To Output Ramp
Press Wave, then use the multifunction knob to select "Ramp", and then press
down the knob to select the waveform. You can also press Wave continuously or
enable the touch screen to select it. At this time, you can set the parameters for the
ramp waveform. For setting methods, refer to descriptions in "
To Output Sine
". This
section only introduces "Symmetry".
SymmetrySymmetry is defined as the percentage that the rising period of ramp takes
up in the whole period (as shown in the figure below).
Figure 21.1 Symmetry Definition
Press Settings > Symmetry, then rotate the multifunction knob or use the pop-up
numeric keypad to set the symmetry of the ramp waveform. The settable range is
from 1% to 100%.
Function/Arbitrary Waveform Generator (Option)
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
303
Loading ...
Loading ...
Loading ...