Loading ...
Loading ...
Loading ...
also tap "Packets", "Details", or "Payload" at the top of the event table to
select it.
If you select "Packets", the decoded data, time, and other information are
displayed in the event table. If you select "Details", the detailed data in the
specified row will be displayed in the event table. If "…" appears in the row of
data, it indicates that the decoded data are not fully displayed. At this time,
you can view the details in the "Packets" view. If you select "Payload", all data
in the specified column will be displayed in the event table. If "…" appears in
the specified column of data, it indicates that the decoded data are not fully
displayed. At this time, you can view the details in the "Packets" view.
- Export: If you select "Packets", you can export time and the corresponding
decoded data. Press Export, then the save setting interface is displayed. You
can export the data table of the packet to the internal memory or the
external USB storage device (when detected) in CSV format. For detailed
saving operation, refer to descriptions in "
Store and Load
".
- Jump to: Set the operating status of the oscilloscope to "STOP". Then, select
the data of the specified time from the event table. Press Jump to and the
specified data waveforms are displayed in the center of the screen.
- Decode: The setting of this menu enables you to quickly view the
corresponding event tables of four decode modules (Decode1, Decode2,
Decode3, and Decode4). Press Decode, then use the multifunction knob
to select a decode module, then press down the knob to select it. You can
also press Decode continuously or enable the touch screen to select it.
6. Interpret the decoded FlexRay frame data
- TSS: transmission start sequence, displayed as a pink patch.
- Sync Frame: displayed as a deep pink patch.
- ID (Frame ID): expressed in Hex, displayed as a blue-green patch.
- PL (Payload Length): expressed in Hex, displayed as a dark blue patch.
- HCRC (Header Cyclic Redundancy Check): expressed in Hex, displayed in yellow-
green. When CRC errors occur, it is displayed as a red patch.
- CYC (Cycle Number): expressed in Hex, displayed as a light blue patch.
Protocol Decoding
270
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Loading ...
Loading ...
Loading ...