Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
632
Virtual Router Redundancy Protocol (VRRP)
Commands
69-1 vrrp authentication
This command is used to enable VRRP authentication and set the password on an interface. Use the no form of this
command to remove the authentication.
vrrp authentication string
no vrrp authentication
Parameters
69-2 vrrp critical-ip
This command is used to set the critical IP address of a virtual router. Use the no form of this command to remove the
critical IP address.
vrrp vrid critical-ip ip-address
no vrrp vrid critical-ip
Parameters
string Specifies the plaintext authentication password (8 bytes).
Default
By default no authentication is configured.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 8. (EI Mode Only Command)
Usage Guideline
This command is used to enable VRRP authentication on an interface. The
authentication is applied to all virtual routers on this interface.
The devices in the same VRRP group must have the same authentication password.
Use the command show vrrp to verify your settings.
Example
This example shows how to configure one interface’s VRRP authentication.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#vrrp authentication test
DXS-3600-32S(config-if)#
vrid Specifies the virtual router identifier. The valid range is from 1 to 255.
ip-address Specifies the critical IP address.
Default
By default, no critical IP address is configured.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 8. (EI Mode Only Command)
Usage Guideline
This command is used to set the critical IP address for one virtual router. If the critical
IP is configured on one virtual router, the virtual router can not be active when the
critical IP address is unreachable. The critical IP address is a valid host address and
must belong to one existing interface on switch.
Use command show vrrp to verify your settings.
Loading ...
Loading ...
Loading ...