Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
575
58-2 storm-control action
This command is used to enable the specified action. Use the no form of this command to configure this option to the
default settings.
storm-control action {block | shutdown | drop}
no storm-control action
Parameters
58-3 storm-control interval
This command is used to configure the interval time. Use the no form of the command to default time
storm-control interval <sec 1-300>
no storm-control interval
Parameters
block Specifies the storm-control block the flooding of which storm packets when the
value specified for rise threshold is reached, and recover the flooding of which storm
packets when the value specified for low threshold is falling.
shutdown Specifies the storm-control to shutdown the port when the value specified for rise
threshold is reached.
drop Specifies the storm-control discard packets that exceed the rise threshold
Default
The default setting of the action is block storm packets.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
If the port shutdown, you must use the no storm-control action or the no storm-
control {broadcast | multicast | unicast} commands to recover the port.
Example
This example shows how to enable the shutdown action on port 1.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#storm-control action shutdown
Success
DXS-3600-32S(config-if)#
interval <sec 1-300> Specifies the time interval that the switch checks the storm. The range of 1 to 300 in
seconds.
Default
The default interval time is 5s.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
In order to maintain the stability of network state, it is recommended to set the time
interval of not less than the default value.
Loading ...
Loading ...
Loading ...