Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
565
spanning-tree
no spanning-tree
57-15 spanning-tree hello-time
This command is used to configure the MSTP port hello time. Use the no form of this command to return the setting to
default setting.
spanning-tree hello-time SECONDS
no spanning-tree hello-time
Parameters
57-16 spanning-tree externalcost
This command is used to configure the STP port external cost. Use the no form of this command to return the setting to
default setting.
spanning-tree externalcost COST
Parameters
None.
Default
The value is disabled in default.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 8
Usage Guideline
The spanning-tree/no spanning-tree command allows the Spanning Tree Protocol to
be enabled/disabled on the switch interface.
Example
This example shows how to enable STP on an interface.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#spanning-tree
Success
DXS-3600-32S(config-if)#
SECONDS Specifies the time interval to send one BPDU at the Designated Port. The default
setting is 2 seconds. The range is 1 to 2 seconds.
Default
The default value is 2.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 8
Usage Guideline
The port hello time is only used in MSTP version. This parameter cannot be
configured in STP or RSTP version.
Example
This example shows how to configure the port hello time.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#spanning-tree hello-time 1
Success
DXS-3600-32S(config-if)#
Loading ...
Loading ...
Loading ...