Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
252
gvrp
no gvrp
22-4 gvrp advertise (Interface)
This command is used to specify that a VLAN should be advertised by the GVRP protocol. Use the no gvrp advertise
interface configuration command to disable this function.
gvrp advertise {all | VLAN-ID [,|-]}
no gvrp advertise { all | VLAN-ID [,|-]}
Parameters
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12
Usage Guideline
You can use the GVRP interface configuration command to enable/disable the
GVRP protocol state.
This command can be configured on physical ports or link aggregation groups.
The GVRP function cannot be enabled when the interface is operating in access
mode or Dot1Q-tunnel mode, meaning that the GVRP function can only be enabled
when the port is operating in trunk or hybrid mode.
Example
This example shows how to enable the GVRP function on Ethernet port 1.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#gvrp
DXS-3600-32S(config-if)#
VLAN-ID [,|-] Specifies a VLAN. The range is 1 to 4094. You can specify a single VLAN-ID, a
range of VLANs separated by a hyphen, or a series of VLANs separated by comma.
all Specifies all VLANs.
Default
All VLANs are able to be advertised.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12
Usage Guideline
This command can be configured on physical ports or link aggregation groups.
You can use the gvrp advertise interface configuration command to enable the
specified VLANs’ GVRP advertise function on the specified interface. If a VLAN is
not in the interface’s advertise-able VLAN set, the interface will never advertise the
VLAN through GVRP message. If all is specified, all VLANs are advertise-able on
this interface.
This command setting only takes effect when GVRP is enabled.
Example
This example shows how to enable the advertise function of VLAN 1-1000 on
interface Ethernet port 1.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#gvrp advertise 1-1000
DXS-3600-32S(config-if)#
Loading ...
Loading ...
Loading ...