Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
332
LLDP-MED Commands
34-1 lldp-med fast-start-repeat-count
This command is used to set the fast start repeat count on the switch. Use the no form of this command to return to the
default settings.
lldp-med fast-start-repeat-count value
no lldp-med fast-start-repeat-count
Parameters
34-2 lldp-med notification-topo-change
This command is used to enable the LLDP MED topology change notification. To disable LLDP MED topology change
notification, use the no form of this command.
lldp-med notification-topo-change
no lldp-med notification-topo-change
34-3 lldp-med tlv-select
This command is used to specify which optional LLDP-MED TLV will be transmitted and encapsulated in the LLDPDUs
and sent to neighbor devices. To disable transmit the TLVs, use the no form of this command.
value Specifies the repeat count range from 1 to 10.
Default
4 times.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12
Usage Guideline
This command is used to configure the fast start repeat count. When an LLDP-MED
Capabilities TLV is detected for an MSAP identifier not associated with an existing
LLDP remote system MIB, then the application layer shall start fast start mechanism
and shall set the ‘medFastStart’ timer to ‘medFastStartRepeatCount’ times 1.
Example
This example shows how to set LLDP MED fast start repeat count.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#lldp-med fast-start-repeat-count 10
DXS-3600-32S(config)#
Parameters
None.
Default
Notification topology state is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12
Usage Guideline
Enable or disable each port for sending topology change notification to configured
SNMP trap receiver(s) if an endpoint device is removed or moved to another port.
Example
This example shows how to set LLDP MED topology change notification.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lldp-med notification-topo-change
DXS-3600-32S(config-if)#
Loading ...
Loading ...
Loading ...