Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
424
43-7 flowcontrol
This command is used to specify the flow control.
flowcontrol {auto | on | off}
no flowcontrol
Parameters
43-8 mtu
This command is used to specify the Maximum Transmission Unit (MTU) of the port.
mtu <64-12288>
no mtu
half Specifies that the communication system will be set to half-duplex.
auto Specifies that the communication system will be set to auto-negotiation.
Default
None.
Command Mode
Port Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
None.
Example
This example shows how to set the communication system for a port.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#duplex full
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no duplex
DXS-3600-32S(config-if-range)#
auto Specifies that the flow control will be set to auto-negotiate.
on Specifies that the flow control option will be enabled.
off Specifies that the flow control option will be disabled.
Default
By default, this option is set to auto.
Command Mode
Port Configuration Mode.
Command Default Level
Level: 15
Usage Guideline
None.
Example
This example shows how to specify the flow control.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#flowcontrol on
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no flowcontrol
DXS-3600-32S(config-if-range)#
Loading ...
Loading ...
Loading ...