Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
595
TELNET Commands
62-1 ip telnet server enable
This command is used to enable the TELNET server on the switch. Use the no form of this command to disable the
TELNET server on the switch.
ip telnet server enable
no ip telnet server enable
62-2 telnet
This command is used to TELNET to a remote server and manage it through the TELNET protocol.
telnet <ip-address> [port]
telnet [vrf <string 1-12>] <ip-address> [port]
Parameters
62-3 show ip telnet server
This command is used to display the TELNET server information.
show ip telnet server
Parameters
None.
Default
By default the TELNET server is enabled.
Command Mode
Global Configure Mode.
Command Default Level
Level: 8
Usage Guideline
This command enables the TELNET server service on the switch. It allows
communication with and management of the switch using the TELNET protocol.
Example
This example shows how to enable the TELNET server on the switch.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip telnet server enable
DXS-3600-32S(config)#
vrf <string 1-12> Specifies the VRF of the TELNET server. If the parameter is not specified, it
indicates the global routing forward space.
ip-address Specifies the IPv4 address of the destination end station.
port Specifies the TCP port number of the TELNET server.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 2
Usage Guideline
This command is used to TELNET to a remove server and manage it through the
TELNET protocol
Example
This example shows how to TELNET to a remove server.
DXS-3600-32S#telnet 10.90.90.91
Parameters
None.
Loading ...
Loading ...
Loading ...