Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
557
Spanning Tree Protocol (STP) Commands
57-1 spanning-tree (global configuration)
This command is used to enable the STP mode. Use no form to disable STP.
spanning-tree
no spanning-tree
57-2 spanning-tree reset
This command is used to restore the Spanning Tree configuration to the default value. This command does not have
the no form.
spanning-tree reset
57-3 spanning-tree (timers)
This command is used to set the value of Spanning-Tree Timers. Use the no form of this command to restore the
default value.
spanning-tree [hello-time SECONDS | forward-time SECONDS | max-age SECONDS]
no spanning-tree [hello-time SECONDS | forward-time SECONDS | max-age SECONDS]
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 8
Usage Guideline
The spanning-tree/no spanning-tree command allows the Spanning Tree Protocol to
be globally enabled/disabled on the switch.
Example
This example shows how to enable STP mode is the default mode.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree
Success
DXS-3600-32S(config)#
5 2000-02-15 00:22:09 INFO(6) Spanning Tree Protocol is enabled
DXS-3600-32S(config)#
Parameters
None.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 8
Usage Guideline
To reset the STP configuration to default.
Example
This example shows how to reset the STP configuration to default.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree reset
Success
DXS-3600-32S(config)#
Loading ...
Loading ...
Loading ...