Loading ...
Loading ...
Loading ...
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
452
no ip pim register-suppression
Parameters
47-6 ip pim rp-address
This command is used to create a static RP in PIM-SM. To delete the static RP entry, use the no form of this command.
ip pim rp-address RP-ADDRESS [ACCESS_LIST]
no ip pim rp-address RP-ADDRESS
Parameters
SECONDS Specifies the value of the register suppression time. The range of this value is 11-
255 seconds.
Default
60 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 8. (EI Mode Only Command)
Usage Guideline
When a DR receives the register-stop message, it will start the suppression timer.
During suppression period, a DR stops sending the register message to the RP.
Use the command on the first hop router.
Please be noted, the parameter Register Probe Time in RFC 4601 is fixed to 5.
Because the value of the Register Probe Time must be less than half the value of the
Register Suppression Time to prevent a possible negative value in the setting of the
Register-Stop Timer, the minimal value for Register Suppression Time is 11.
To verify your configuration, use command show ip pim.
Example
This example shows how to configure the PIM register suppression to be 100
seconds.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim register-suppression 100
DXS-3600-32S(config)#
Example
This example shows how to restore the default value.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip pim register-suppression
DXS-3600-32S(config)#
RP-ADDRESS Specifies the IP address of the RP.
ACCESS_LIST Specifies the name of the access list.
Default
No any static RP entry.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 8. (EI Mode Only Command)
Loading ...
Loading ...
Loading ...