Loading ...
Loading ...
Loading ...
WHEELS AND TIRES
}}
* Option/accessory.
561
1. Turn on the vehicle's hazard warning flashers
if a wheel change must be performed in an
area with traffic.
2. Apply the parking brake and put the gear
selector in P.
For vehicles with
Leveling Control*: If the
vehicle is equipped with pneumatic suspen-
sion, this must be switched off before the
vehicle is lifted with the jack*.
3.
Take out the jack*, lug wrench* and tool for
removing the plastic covers, which are
stowed in the foam block.
Tool for removing the plastic covers on the wheel bolts.
4. Place chocks in front of and behind the
wheels that are still on the ground. For exam-
ple, use heavy wooden blocks or large
stones.
5.
Using the lug wrench*, screw the towing eye
into place as far as possible according to the
instructions.
CAUTION
The towing eyelet must be screwed into the
lug wrench* as far as possible.
6. Remove the plastic covers from the wheel
bolts using the designated tool.
7. With the vehicle still on the ground, use the
lug wrench/towing eye to loosen the wheel
bolts ½-1 turn by pressing downward (coun-
terclockwise).
8. When hoisting the vehicle, it is important that
the jack* or garage lift arms are positioned
on the designated points under the vehicle.
The triangle markings on the plastic cover
indicate where the jack attachment points/
lifting points are located. There are two jack
attachment points on each side of the vehi-
cle. There is a groove for the jack at each
attachment point.
9. Position the jack under the attachment point
being used, ensuring that the surface is firm,
flat and not slippery.
Loading ...
Loading ...
Loading ...