Loading ...
Loading ...
Loading ...
(408,1)
[ Edit: 2020/ 8/ 19 Model: T32-A ]
6-10 In case of emergency
JVE0363X
M9R engine model
WAG0019X
HR13 engine model
1. If the booster battery is in another vehicle
, position the two vehicles and to
bring the batteries into close proximity to
each other.
CAUTION:
If the battery of vehicle
equipped with the
Intelligent Key system is discharged, the
ignition switch cannot be placed from the
“LOCK” position and, if the steering lock is
engaged, the steering wheel cannot be
moved. Connect the jumper cables to the
booster vehicle
before turning or pushing
the ignition switch and disengaging the
steering lock.
2. Apply the parking brake.
3. Continuously Variable Transmission (CVT)/
Dual Clutch Transmission (DCT) model:
Move the shift lever to the “P” (Park)
position.
Manual Transmission (MT) model: Move the
shift lever to the “N” (Neutral) position.
4. Switch off all unnecessary electrical sys-
tems (headlights, heater, air conditioner,
etc.).
5. Place the ignition switch in the “LOCK”
position.
6. Remove the vent caps, if equipped, on the
battery.
7. Cover the battery with a firmly wrung out
moist cloth to reduce the hazard of an
explosion.
8. Connect the jumper cables in the sequence
as illustrated (
, , , ).
CAUTION:
. Always connect positive + to positive +
and negative 7 to body ground, NOT to
the battery’s negative 7.
. Be sure that the jumper cables do not
touch moving parts in the engine com-
partment.
. Be sure that the jumper cable’s clamps do
not contact any other metal.
9. Start the engine of the booster vehicle
and let it run for a few minutes.
10. Depress the accelerator pedal of the boos-
ter vehicle
at about 2,000 rpm.
11. Start the engine of the jumped vehicle
in
the normal manner.
CAUTION:
Never keep the starter motor engaged for
more than 10 seconds. If the engine does not
start right away, place the ignition switch
“OFF” and wait at least 10 seconds before
trying again.
12. After the engine is started, carefully dis-
connect the jumper cables in the opposite
sequence from that illustrated (
, , , ).
13. Remove and dispose of the cloth as it may
be contaminated with corrosive acid.
14. Replace the vent caps, if removed.
NOTE:
. For model with Stop/Start System or
Idling Stop System, use the special bat-
tery that is enhanced in regard to the
charge-discharge capacity and life per-
formance. Avoid using a non-special bat-
tery for the Stop/Start System or Idling
Stop System, as this may cause early
deterioration of the battery or a malfunc-
tion of the Stop/Start System or Idling
Stop System. For the battery, it is recom-
mended to use Genuine NISSAN parts. For
more information, contact a NISSAN deal-
er.
. For model with Stop/Start System or
Idling Stop System, it may take some
time until Stop/Start System or Idling
Stop System activates when the battery
is replaced or the battery terminal is
disconnected for extended periods and
then reconnected. Also, in the first trip
after the jump starting, Idling Stop Sys-
tem will not be activated.
Condition: 'Except for China'/
Loading ...
Loading ...
Loading ...