Loading ...
Loading ...
Loading ...
(318,1)
[ Edit: 2020/ 8/ 19 Model: T32-A ]
5-26 Starting and driving
. when the shift lever is placed in the “D”
(Drive) position from the “N” (Neutral) or
“P” (Park) position (for CVT model).
. when the shift lever is placed in the “D”
(Drive) position from the “N” (Neutral) or
“P” (Park) position and the brake pedal is
released (for DCT model).
. when the shift lever is placed in the “R”
(Reverse) position from the “N” (Neutral)
or “P” (Park) position (for CVT/DCT model).
. when the driver’s seat belt is unfastened,
or the driver’s door is open (for CVT/DCT
model).
. when the battery voltage becomes low
(due to electrical load from other vehicle
systems like headlights, heaters, etc., or
auxiliary devices connected to the 12 volt
socket inside the vehicle).
. when the vehicle speed is above about 2
km/h (1 MPH).
. when the temperature inside the vehicle
is too high or low. (When the air condi-
tioner is off, the Stop/Start System or
Idling Stop System will operate.)
. when the front defogger is turned on.
(The engine may not starts depending on
the outside temperature.)
. when more than 3 minutes have elapsed
since the Stop/Start System or Idling
Stop System was active (for CVT/DCT
model).
. when the accelerator pedal is depressed
(for CVT/DCT model).
. when the steering wheel is operated. (The
steering wheel operation may become
heavy, but this is not a malfunction.) (for
CVT/DCT model)
. when the battery capacity is low.
. when the power consumption is high.
. when the shift lever is placed in the “R”
(Reverse) position (for CVT/DCT model).
. when the clutch pedal is depressed (for
MT model).
. when the vacuum in the brake servo
decreases.
CAUTION:
Only engage gear when the clutch pedal is
fully depressed (for MT model).
NOTE:
The following conditions will prevent the
Stop/Start System or Idling Stop System
from automatically restarting the engine.
Starting the engine with the ignition switch
operation is then necessary:
. the driver’s seat belt is unfastened, and
driver’s door is open (for MT model).
. the hood is open.
If there is a malfunction with the Dual Clutch
Transmission (DCT) system, the engine will be
stalled (for DCT model).
Use this system while waiting at stoplight, etc.
When the vehicle is stopped for long periods of
time, turn off the engine.
When the engine is stopped by the Stop/Start
System or Idling Stop System, heating, cooling
and dehumidifying functions will be deacti-
vated. To avoid the air conditioning functions
from being deactivated, turn off the Idling Stop
mode by pressing the Stop/Start or Idling Stop
OFF switch.
STOP/START SYSTEM OR IDLING STOP
SYSTEM DISPLAY
GUID-D56CB066-F6D6-49D2-82F7-415D8907262F
Engine stop
GUID-78FEA13F-8F8D-4B8D-BC97-67B76FF15251
JVS0341X
When the engine is stopped the information is
displayed for a few seconds.
Stop/Start system or Idling Stop Sys-
tem ON or OFF
GUID-6BC66795-C2D6-4F71-9A5B-5ECF0E05EDF2
JVS0638X
If the Stop/Start System or Idling Stop System
is activated or deactivated using the Stop/Start
or Idling Stop OFF switch, the message is
shown.
Condition: 'Except for China'/
Loading ...
Loading ...
Loading ...