Loading ...
Loading ...
Loading ...
Replacement of light bulbs
Vehicle care and maintenance 9-33
9
2. After removing the two screws (A), move
the light unit rearward and remove the
three light unit pins (B).
3. Turn the rear turn-signal light socket
counterclockwise and remove it, and then
pull the bulb out of the socket.
4. To install the bulb, perform the removal
steps in reverse.
N00929101093
1. Remove the three clips (A), and then pull
back the splash shield (B).
2. Turn the socket (C) counterclockwise to
remove it, and then pull the bulb out of
the socket.
3. To install the bulb, perform the removal
steps in reverse.
NOTE
It will be easier to remove the light unit if
you insert a minus screwdriver with the end
covered with a cloth or other object into the
space under the light unit and remove the
highest pin, and then pull the light unit at an
upward angle.
C- Rear turn-signal light
D- Stop light (LED) - cannot be replaced
NOTE
The rear side-marker light, tail light and stop
light use an LED type bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
Back-up lights
*: Rear of the vehicle
BK0277700US.book 33 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...