Loading ...
Loading ...
Loading ...
HomeLink® Wireless Control System (if so equipped)
Features and controls 5-213
5
N00584600029
Some garage door openers manufactured
after 1995 have “rolling code protection”.
To program a garage door opener
equipped with “rolling code protection”;
you will need to access the garage door
opener motor to press the motor’s “Learn”
or “Smart” buttons. For convenience, use
a ladder and another person to assist you.
It is recommended that a new battery be
placed in the hand-held transmitter of the
device being programmed to HomeLink
®
for quicker training and accurate trans-
mission of the radio-frequency signal.
N00584700046
To program HomeLink
®
to operate a garage
door, gate, entry door opener, home or office
lighting, you need to be at the same location
as the device.
1. Press the HomeLink
®
button that you
would like to program. The indicator light
(A) will flash orange slowly.
2. Position the end of your hand-held trans-
mitter (B) 1 to 3 inches (2 to 8 cm) away
from the HomeLink
®
button while keep-
ing the indicator light in view.
You can program a maximum of 3 devices.
To change or replace any of the 3 devices
after it has been initially programmed, you
must first erase the current settings.
See “Clearing the programmed information”
on page 5-216 or “Reprogramming a single
HomeLink
®
button” on page 5-217.
1-
HomeLink
®
button 1
2-
HomeLink
®
button 2
3-
HomeLink
®
button 3
NOTE
Before programming Home-
Link
®
Programming a new Home-
Link
®
NOTE
You do not need to continue holding the
HomeLink
®
button.
If the indicator light does not flash, refer to
“Clearing the programmed information” on
page 5-216.
BK0277700US.book 213 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...