Loading ...
Loading ...
Loading ...
HomeLink® Wireless Control System (if so equipped)
5-214 Features and controls
5
3. Press and hold the hand-held transmitter
button while watching the indicator light
(A). Continue pressing the button until the
indicator light (A) changes from slowly
flashing orange to either rapidly flashing
green (rolling code) or continuously lit
green (fixed code). Now you may release
the hand-held transmitter button.
4. Press the HomeLink
®
button that was just
programmed and observe the indicator
light.
• If the indicator light continuously illumi-
nates green, programming is complete
and your device should operate when the
HomeLink
®
button is pressed and
released.
• If the indicator light rapidly flashes
green, firmly press, hold for 2 seconds
and release the programmed HomeLink
®
button. Repeat the “press/hold/release”
sequence a second time, and, depending
on the brand of the garage door opener
(or other rolling code equipped device),
repeat this sequence a third time to com-
plete the programming process. At this
point if your device operates, program-
ming is complete.
• If the device does not operate, continue
with “Programming a new HomeLink
®
”
steps 5 to 7 to complete the program-
ming of a rolling code equipped device.
5. At the garage door opener receiver
(motor-head unit) in the garage, locate the
“Learn” or “Smart” button. This can usu-
ally be found where the hanging antenna
wire is attached to the motor-head unit
(see the garage door opener manual to
identify the “Learn” button.)
6. Firmly press and release the “Learn” or
“Smart” button. (The name and color of
the button may vary by manufacturer.)
There are typically 30 seconds to initiate
step 7.
7. Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed HomeLink
®
button. Repeat the
“press/hold/release” sequence a second
time, and, depending on the brand of the
garage door opener (or other rolling code
equipped device), repeat this sequence a
third time to complete the programming
process.
HomeLink
®
should now activate your
rolling code equipped device.
NOTE
Some hand-held transmitters may actually
train better from a distance of 6 to 12 inches
(15 to 30 cm). Keep this in mind if you have
difficulty with the programming process.
NOTE
Some devices may require you to replace this
“Programming a new HomeLink
®
” step 3
with procedures noted in the “Gate operator /
Canadian programming” section. If the indi-
cator light does not change to rapidly flash-
ing green or continuously lit green after
performing these steps, contact HomeLink
®
at www.homelink.com.
BK0277700US.book 214 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...