Loading ...
Loading ...
Loading ...
HomeLink® Wireless Control System (if so equipped)
Features and controls 5-215
5
N00584800021
Canadian radio-frequency laws require trans-
mitter signals to “time-out” (or quit) after
several seconds of transmission - which may
not be long enough for HomeLink
®
to pick
up the signal during programming. Similar to
this Canadian law, some U.S. gate operators
are designed to “time-out” in the same man-
ner.
The indicator LED on the hand-held transmit-
ter will go off when the device times out indi-
cating that it has finished transmitting.
If you live in Canada or you are having diffi-
culties programming a gate operator or
garage door opener by using the “Program-
ming” procedures, replace “Programming a
new HomeLink
®
” step 3 with the following:
3. Press and release - every 2 seconds
(“cycle”) your hand-held transmitter until the
HomeLink
®
indicator light changes from
slowly flashing orange to either rapidly flash-
ing green (rolling code) or continuously lit
green (fixed code). Now you may release the
hand-held transmitter button.
Proceed with “Programming a new Home-
Link
®
” step 4 to complete.
N00584900022
The HomeLink
®
has the capability of receiv-
ing garage door status from compatible
garage door opener systems. Check your
garage door opener manual for the available
feature and HomeLink
®
compatibility. Also
for a listing of compatible systems contact
HomeLink
®
at: www.homelink.com
1. Within 5 seconds after successfully pro-
gramming the garage door opener (refer
to “Programming a new HomeLink
®
”
section), both garage door operation indi-
cators (A) will flash rapidly green indicat-
ing that the garage door feedback has
been enabled.
If the indicators do not flash, perform
steps 2 and 3 while pressing the Home-
Link
®
button up to the first 10 times after
successful programming.
2. Press and release the programmed Home-
Link
®
button to activate the door. You
now have 1 minute in which to complete
step 3.
NOTE
In the event that there are still programming
difficulties or questions, additional Home-
Link
®
information and programming videos
can be found online at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
®
Hotline.
Gate operator/Canadian pro-
gramming
NOTE
If programming a garage door opener or gate
operator, it is advised to unplug the device
during the “cycling” process to prevent pos-
sible overheating.
Additional steps for program-
ming a door system with feed-
back
BK0277700US.book 215 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...