Loading ...
Loading ...
Loading ...
HomeLink® Wireless Control System (if so equipped)
5-216 Features and controls
5
3. Once the door has stopped, press and
release the “Learn” or “Smart” button on
the garage door opener (refer to your
garage door opener owner’s manual for
the location of the “Learn” button). Both
the HomeLink
®
garage door operation
indicators will flash rapidly green upon
successful synchronization with the door
opener (within 5 seconds).
N00585000020
To operate, simply press and release the pro-
grammed HomeLink
®
button. Activation will
now occur for the trained device (i.e. garage
door opener, gate operator, security system,
entry door lock, home/office lighting, etc.).
For convenience, the hand-held transmitter of
the device may also be used at any time.
N00585200022
The HomeLink
®
has the capability of receiv-
ing garage door status from compatible
garage door opener systems. Refer to “Addi-
tional steps for programming a door system
with feedback” on page 5-215.
Garage door status is then displayed with
indicators (A).
The indicators will illuminate/blink in
response to the following conditions:
: Blinking : Illuminates
The HomeLink
®
has the capability of listen-
ing to these messages at a range up to 820.2
feet (250 m) (open line of sight), but range
may be reduced by obstacles such as houses
or trees. You may have to slow your vehicle
speed to receive the CLOSED or OPENED
message feedback from the garage door
opener. If the unit is out of range before
receiving either the UP or DOWN message
from the door opener, both the UP and
DOWN indicators will flash red followed by
a continuous lit orange indicator in the direc-
tion the door was last moving.
Recall of the door state after initial feedback
is possible by simultaneously pressing either
HomeLink
®
buttons 1 and 2 or buttons 2 and
3 for 2 seconds. The last recorded message
will be displayed for 3 seconds, again follow-
ing the garage door status indication of the
figure above.
N00585300049
To erase programming from the 3 buttons
(individual buttons cannot be erased but can
be “reprogrammed” as outlined below), fol-
low the steps noted:
Operating HomeLink
®
Garage door feedback
Garage door opener closing
(orange)
Garage door opener closed
(green)
Out of range
(red)
Garage door opener opening
(orange)
Garage door opener opened
(green)
Out of range
(red)
Clearing the programmed
information
BK0277700US.book 216 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...