OWNER'S MANUAL - Page 298

For 2020 ECLIPSE CROSS.

Loading ...
Loading ...
Loading ...
HomeLink® Wireless Control System (if so equipped)
Features and controls 5-217
5
1. Press and hold the 2 outer HomeLink
®
buttons for at least 10 seconds. The indi-
cator will change from continuous yellow
to rapidly flashing green.
2. Release both buttons.
3. HomeLink
®
is now in the training (or
learning) mode and can be programmed at
any time beginning with “Programming a
new HomeLink
®
” step 1.
N00585400024
To reprogram a HomeLink
®
button, complete
the following.
1. Press and hold the desired HomeLink
®
button. Do not release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The Home-
Link
®
button can be released at this point.
Proceed with “Programming a new
HomeLink
®
” step 2.
N00585600042
Your HomeLink
®
system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of the FCC Rules and
RSS-210 of the Industry Canada Rules. Oper-
ation is subject to the following two condi-
tions.
This device may not cause harmful inter-
ference.
This device must accept any interference
that may be received, including interfer-
ence that may cause undesired operation.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. End Users must follow the spe-
cific operating instructions for satisfying RF
exposure compliance. This transmitter must
be at least 8 inches (20 cm) from the user and
must not be co-located or operating in con-
junction with any other antenna or transmit-
ter.
The term “IC:” before the certification/regis-
tration number only signifies that Industry
Canada technical specifications were met.
NOTE
Do not hold for longer than 20 seconds.
Reprogramming a single
HomeLink
®
button
NOTE
If you do not complete the programming of a
new device to the button, it will revert to the
previously stored programming.
For questions or comments, visit
www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
®
Hotline.
General information
CAUTION
The transmitter has been tested and complies
with FCC and IC rules.
Changes or modifications not expressly
approved by the party responsible for com-
pliance could void the users authority to
operate the device.
BK0277700US.book 217 ページ 2019年3月8日 金曜日 午前9時23分
Loading ...
Loading ...
Loading ...