Loading ...
Loading ...
Loading ...
Cruise control
Features and controls 5-91
5
The set speed driving is deactivated automati-
cally in any of the following ways.
When your speed slows to approximately
10 mph (15 km/h) or more below the set
speed because of a hill, etc.
When your speed slows to approximately
20 mph (30 km/h) or less.
When the active stability control (ASC)
starts operating.
Refer to “Active stability control (ASC)”
on page 5-84.
Also, the set speed driving may be deacti-
vated as follow:
When the engine speed rises and
approaches the tachometer’s red zone (the
red-colored part of the tachometer dial).
N00518901420
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-90, you can resume the previously set
speed by push up the “RES +” switch while
driving at a speed of approximately 20 mph
(30 km/h) or higher.
The “SET” indicator appears on the informa-
tion screen of the multi-information display.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
The CRUISE CONTROL ON/OFF
switch is pressed.
The ignition switch is turned to the “OFF”
position or the operation mode is put in
OFF.
Indicator go off.
WARNING
Although the set speed driving will be
deactivated when shifting to the “N”
(NEUTRAL) position, never move the
selector lever to the “N” (NEUTRAL)
position while driving.
You would have no engine braking and
could cause a serious accident.
CAUTION
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by an authorized
Mitsubishi Motors dealer or a repair facility
of your choice.
To resume the set speed
BK0277700US.book 91 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...