Loading ...
Loading ...
Loading ...
Tire pressure monitoring system (TPMS)
5-130 Features and controls
5
A window tint that affects the radio wave
signals is installed.
N00532900081
If new wheels with new tire inflation pressure
sensors are installed, their ID codes must be
programmed into the tire pressure monitoring
system. Have tire and wheel replacement per-
formed by an authorized Mitsubishi Motors
dealer to avoid the risk of damaging the tire
inflation pressure sensors. If the wheel
replacement is not done by an authorized
Mitsubishi Motors dealer, it is not covered by
your warranty.
N00584300042
In case that 2 sets of tire inflation pressure
sensor ID are registered in the receiver, the
valid tire ID set can be changed by following
procedure.
1. Switch to the function setting screen.
Refer to “Multi-information display
switches” on page 5-145.
Refer to “Changing the function settings”
on page 5-155.
2. Press the switch or switch several
times to switch to the “TPMS ID” screen.
Then, press the switch to the setting
selection screen.
3. Press the switch or switch to
select the “ID 1” or “ID 2”, and then press
and hold the switch for approximately
3 seconds or more to confirm the setting.
4. The valid tire ID set is changed, and the
number of the tire pressure monitoring
system (TPMS) SET indicator is changed.
N00533001233
Your tire pressure monitoring system oper-
ates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
(For vehicles sold in U.S.A.) and Industry
Canada Rules (For vehicles sold in Canada).
This device complies with part 15 of FCC
NOTE
Tire inflation pressures vary with the ambi-
ent temperature. If the vehicle is subjected to
large variations in ambient temperature, the
tire inflation pressures may be under-inflated
(causing the warning light / display come on)
when the ambient temperature is relatively
low. If the warning light / display comes on,
adjust the tire inflation pressure.
Whenever the tires and wheels
are replaced with new ones
CAUTION
The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting air leakage or damage of
the sensors.
Tire ID set change
NOTE
The tire ID set is NOT changed, in case that
only 1 set of ID is registered.
General information
BK0277700US.book 130 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...