Loading ...
Loading ...
Loading ...
4-wheel drive operation
Features and controls 5-73
5
When turning a sharp corner in “GRAVEL”
position at low speed, a slight difference in
steering may be experienced similar to feel-
ing as if the brakes were applied. This is
called tight corner braking and results from
each of the four tires being at a different dis-
tance from the corner. The phenomenon is
typical of 4-wheel drive vehicles. If this
occurs, either straighten out the steering
wheel or change to another mode.
Set the drive mode-selector to “SNOW” in
accordance with the road conditions, and then
gradually depress the accelerator pedal for a
smooth start.
Set the drive mode-selector to “GRAVEL”
and then gradually depress the accelerator
pedal for a smooth start. Keep the pressure on
the accelerator pedal as constant as possible,
and drive at low speed.
NOTE
Driving on rough roads can be hard on a
vehicle. Before you leave the pavement, be
sure all scheduled maintenance and service
has been done, and that you have inspected
your vehicle. Pay special attention to the
condition of the tires, and check the tire pres-
sures.
Mitsubishi Motors is not responsible to the
operator for any damage or injury caused or
liability incurred by improper and negligent
operation of a vehicle. All techniques of
vehicle operation depend on the skill and
experience of the operator and other partici-
pating parties. Any deviation from the rec-
ommended operating instructions above is at
their own risk.
Note that the stopping distance required of
the 4-wheel drive vehicle differs very little
from that of the front-wheel drive vehicle.
When driving on a snow-covered road or a
slippery, muddy surface, make sure that you
keep a sufficient distance between your vehi-
cle and the one ahead of you.
The driving posture should be more upright;
adjust the seat to a good position for easy
steering and pedal operation. Be sure to wear
the seat belt.
After driving on rough roads, check each
part of the vehicle and wash it thoroughly
with water. Refer to the “Inspection and
maintenance following rough road opera-
tion” section and “Vehicle care and Mainte-
nance” sections.
CAUTION
Setting the drive mode-selector to
“GRAVEL” and “SNOW” position to drive
on dry paved road will increase fuel con-
sumption, with possible noise and vibration
generation.
Turning sharp corners
On snowy or icy roads
NOTE
The use of snow tires is recommended.
Maintain a safe distance between vehicles,
avoid sudden braking, and use engine brak-
ing (downshifting).
CAUTION
Avoid sudden braking, sudden acceleration
and sharp turning. Skidding occurs and con-
trol of the vehicle could be lost.
Driving on sandy or muddy
roads
CAUTION
Do not force the vehicle or drive recklessly
on sandy surfaces. In comparison with nor-
mal road surfaces, the engine and other
drive-system components are put under
excessive strain when driving on such a sur-
face. This could lead to accidents.
If any of the following conditions occur
while the vehicle is being driven, immedi-
ately park your vehicle in a safe place and
follow these procedures:
NOTE
BK0277700US.book 73 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...