Loading ...
Loading ...
Loading ...
Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
5-26 Features and controls
5
3. If the engine still will not start, the engine
could be flooded with too much gasoline.
While depressing the brake pedal, push
the accelerator pedal all the way down
and hold it there, then press the engine
switch to crank the engine. If the engine
does not start after 5 to 6 seconds, push
the engine switch to stop cranking the
engine, and release the accelerator pedal.
Put the operation mode in OFF. Wait a
few seconds, and then press the engine
switch to crank the engine again while
depressing the brake pedal, but do not
push the accelerator pedal. If the engine
fails to start, repeat these procedures. If
the engine still will not start, contact your
local Mitsubishi Motors dealer or a repair
facility of your choice for assistance.
Startability of the engine with an ambient
temperature of -22 °F (-30 °C) or lower
When the ambient temperature is -22 °F (-30
°C) or lower, it may not be possible to start
from a standstill even with the selector lever
in the “D” (DRIVE) or “R” (REVERSE)
position.
This phenomenon occurs because the trans-
axle has not warmed up sufficiently; it does
not indicate a problem. If this occurs, place
the selector lever in the “P” (PARK) position
and let the engine idle for at least 10 minutes.
The transaxle will warm up, and you will be
able to start normally.
Do not leave the vehicle during warm-up
operation.
N00568201053
1. Stop the vehicle.
2. Fully engage the parking brake while
depressing the brake pedal.
3. Move the selector lever to the “P”
(PARK) position, and then press the
engine switch to stop the engine.
N00568301113
The following operation can be used to start
the engine or change the operation mode.
1. Depress the brake pedal firmly with your
right foot.
2. While depressing the brake pedal, touch
the portion of the F.A.S.T.-key shown in
the illustration to the engine switch.
Stopping the engine
WARNING
Do not operate the engine switch while
driving except in an emergency. If the
engine is stopped while driving, the brake
servomechanism will cease to function and
braking efficiency will deteriorate. Also,
the power steering system will not func-
tion and it will require greater manual
effort to operate the steering. This could
result in a serious accident.
NOTE
If you have to bring the engine to an emer-
gency stop while driving, press and hold the
engine switch for 3 seconds or more, or press
it quickly three times or more. The engine
will stop and the operation mode will go to
ACC.
Do not stop the engine with the selector lever
in any position other than the “P” (PARK)
position. If the engine is stopped with the
selector lever in any position other than the
“P” (PARK) position, the operation mode
will go to ACC rather than OFF.
Put the operation mode in OFF after placing
the selector lever in the “P” (PARK) posi-
tion.
If the F.A.S.T.-key is not operat-
ing properly
NOTE
BK0277700US.book 26 ページ ２０１９年３月８日 金曜日 午前９時２３分
Loading ...
Loading ...
Loading ...