Loading ...
Loading ...
Loading ...
Measurements
R&S
®
RTC1000
88User Manual 1335.7352.02 ─ 04
If "n/a" is displayed, the measurement is not applicable to the signal. For instance, if
you measure a voltage on a POD, no result is displayed because only logic states with-
out voltage reference are displayed.
If "?" is displayed, the display does not show a complete measurement result. For
instance, the period to be measured is not completely displayed and cannot be identi-
fied.
7.3.1 Settings for Automatic Measurements
â–º Press the [AUTO MEASURE] key in the Analysis section.
Figure 7-2: Auto measurement settings and results
MEAS. PLACE
Selects the measurement place. To each measurement place, an automatic measure-
ment function is assigned.
MEASURE
Switches the selected measurement place on or off.
TYPE
Defines the measurement type. To learn about the types, see
Chapter 7.3.2, "Auto-
matic Measurement Types"
, on page 89).
Automatic Measurements
Loading ...
Loading ...
Loading ...