Loading ...
Loading ...
Loading ...
Remote Commands Reference
R&S
®
RTC1000
226User Manual 1335.7352.02 ─ 04
Parameters:
<MeasType> FREQuency | PERiod | PEAK | UPEakvalue | LPEakvalue |
PPCount | NPCount | RECount | FECount | HIGH | LOW |
AMPLitude | CRESt | MEAN | RMS | RTIMe | FTIMe | PDCYcle |
NDCYcle | PPWidth | NPWidth | CYCMean | CYCRms |
STDDev | TFRequency | TPERiode | DELay | PHASe | BWIDth |
POVershoot | NOVershoot
FREQuency
Frequency of the signal. The result is based on the length of the
leftmost signal period within the displayed section of the wave-
form of the selected channel.
PERiod
Length of the left-most signal period within the displayed section
of the waveform of the selected channel.
PEAK
Peak-to-peak value within the displayed section of the waveform
of the selected channel.
UPEakvalue
Maximum value within the displayed section of the waveform of
the selected channel.
LPEakvalue
Minimum value within the displayed section of the waveform of
the selected channel.
PPCount
Counts positive pulses.
NPCount
Counts negative pulses.
RECount
Counts the number of rising edges.
FECount
Counts the number of falling edges.
HIGH
Mean value of the high level of a square wave.
LOW
Mean value of the low level of a square wave.
AMPLitude
Amplitude of a square wave.
CRESt
The crest factor (peak-to-average ratio) is calculated from the
maximum value divided by the RMS value of the waveform
(Crest).
MEAN
Mean value of the complete displayed waveform of the selected
channel.
RMS
Measurements
Loading ...
Loading ...
Loading ...