Loading ...
Loading ...
Loading ...
Mixed Signal Operation (Option R&S RTC-B1)
R&S
®
RTC1000
110User Manual 1335.7352.02 ─ 04
Figure 9-3: Bit DAC signal change
9.2 Logic Trigger for Digital Input
To trigger on logic channels, you can use the logic trigger, see
Chapter 5.5, "Logic Trig-
ger"
, on page 52.
9.3 Cursor Measurements for Logic Channels
If the logic channels active, you can determine several parameters using cursor mea-
surements ([CURSOR MEASURE] key).
The following measurement types are available:
●
TIME:
The display shows the time position of both cursors relative to the trigger time, the
time difference between the two positions and the resulting frequency.
●
RATIO X:
Three cursors are used to display a time ratio between the first two cursors plus the
first and third cursor. The results are shown in floating point format, in percent, in
degrees and in radians.
●
V-MARKER:
Cursor Measurements for Logic Channels
Loading ...
Loading ...
Loading ...