Loading ...
Loading ...
Loading ...
DGS-1520 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
319
Parameter Description
Connect Retry Interval
Enter the connect retry interval time value here. The range is from 1 to 65535
seconds. This is used to configure the interval at which MSDP peers will wait after
peering sessions are reset before attempting to re-establish. A larger time interval
will delay the time before attempting to re-establish the peer session. For best
results, configure the value in the range from 1 to 60 seconds. By default, this
value is 30 seconds.
Select the Default option to use the default value.
SA Cache Expiry Time
Enter the Source-Active (SA) cache expiry time value here. The range is from 65
to 65535 seconds. This is used to configure the expiry time for SA cache entries.
The interval for SA originating is 60 seconds and it cannot be modified, so the SA
cache expiry time allows for the tuning of expected packet loss on a network
implicitly.
Select the Default option to use the default value.
SA Originating Filter Select the Configured option and enter the SA originating filter string here. This
string can be up to 32 characters long. An RP is configured to run MSDP and will
originate SA messages for all local sources that register with this RP. By
configuring the filter with a list, an RP will only originate SA messages for local
sources by sending to specified groups that match (S, G) pairs defined in standard
IP access list.
By selecting the Configured option and not specifying the filter string, an RP from
originating SA messages for all local sources can be prevented.
Click the Apply button to accept the changes made.
MSDP Peer Settings
This window is used to display and configure the MSDP peer settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > MSDP > MSDP Peer
Settings, as shown below:
Figure 6-123 MSDP Peer Settings Window
The fields that can be configured are described below:
Parameter Description
IP MSDP Peer
Enter the MSDP peer IP address here.
Connection Interface
Enter the connect interface name here. This string can be up to 12 characters
long. This specifies the local interface that is used as the source IP address for
TCP connections.
Click the Apply button to accept the changes made.
Loading ...
Loading ...
Loading ...