Loading ...
Loading ...
Loading ...
DGS-1520 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
258
OSPFv2 Virtual Link Settings
This window is used to display and configure OSPFv2 virtual link settings. If a non-zero area is not physically
connected to the zero area, it must be connected to the zero area via a virtual link. The virtual link is a point-to-point
link. The router will send the OSPF message to the neighbor router as unicast IP packet.
To view the following window, click L3 Features > OSPF > OSPFv2 > OSPFv2 Virtual Link Settings, as shown
below:
Figure 6-46 OSPFv2 Virtual Link Settings Window
The fields that can be configured in OSPF Virtual Link are described below:
Parameter Description
Area ID
Select and enter the OSPFv2 area ID here. This can be specified in the IP address
format or in the decimal value format. The decimal range is from 0 to 4294967295.
This area will be used to establish the virtual link.
Router ID
Enter the router ID of the virtual link neighbor here.
Hello Interval
Enter the hello packet interval that the router sends on the virtual link here. The
range is from 1 and 65535 seconds. By default, this value is 10 seconds.
Select the Default option to use the default value.
Dead Interval
Enter the Dead Interval time after which a neighbor is regarded as offline if no hello
packets are received within that time frame here. The range is from 1 and 65535
seconds. By default, this value is 40 seconds.
Select the Default option to use the default value.
Authentication Select the authentication type used here. Options to choose from are None,
Simple Password, and MD5.
Password After selecting the Simple Password authentication type, enter the password to
be used here. This password can be up to 8 characters long.
MD5 Key ID After selecting the MD5 authentication type, enter the MD5 authentication key ID
here. The range is from 1 to 255.
MD5 Key After selecting the MD5 authentication type, enter the MD5 authentication key
here. This key can be up to 16 characters long.
Click the Apply button to accept the changes made.
Click the Delete button to delete the specified entry.
Double-click on the entry in the table to view detailed information about the entry.
Loading ...
Loading ...
Loading ...