Loading ...
Loading ...
Loading ...
WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise risk of accident.
■
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.
■
The beam range is sufficient for safe driving.
Note
■
If, with a dipped beam, the ignition is turned off, then the dipped beam will
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the KESSY system, after opening the driver's door).
■
If there is a fault in the light switch, the low beam comes on automatically.
Daytime running lights
The daytime running light (hereinafter referred to as "function") lights the
front and rear vehicle area (only valid for some countries).
The lights are switched on automatically if the following conditions are
met.
The light switch is in the position
or
.
The ignition is switched on.
The function is activated.
Activating/deactivating function on vehicles with Infotainment
The function can be deactivated/activated in the Infotainment system in menu
→ →
Light
.
Deactivating on vehicles without Infotainment
›
Turn off the ignition, pull the indicator/main beam lever towards the steering
wheel, push down and hold in this position.
›
Switch on the ignition and hold the lever in the above position until you hear
a signal (about 3 s).
Activating on vehicles without Infotainment
›
Turn off the ignition, pull the indicator/main beam lever towards the steering
wheel, push up and hold in this position.
›
Switch on the ignition and hold the lever in the above position until you hear
a signal (about 3 s).
WARNING
Always switch on the low beam when visibility is poor.
Turn signal and main beam
Fig. 54
Operating lever: Turn signal and
main beam operation
Control stalk positions » Fig. 54
Switch on right turn signal
Switch on left turn signal
Switch on main beam (spring-tensioned position)
Switching off main beam / switching on headlamp flasher (spring-loaded
position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be used even if the ignition is switched off.
The turn signal switches off automatically, depending on the steering angle af-
ter completing the turn.
Comfort flashing
When the operating lever is pressed lightly up or down, the indicator in ques-
tion flashes three times.
If, during the comfort signalling, the operating lever is pressed in the opposite
direction, the indicating will stop.
Comfort flashing can be activated / deactivated in the Infotainment menu
→ →
Light
.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.
61
Lights and visibility
Loading ...
Loading ...
Loading ...