Loading ...
Loading ...
Loading ...
Operational faults
Read and observe and on page 58 first.
Repeatedly opening and closing the window can cause the window mechanism
to overheat and become temporarily blocked. You will be able to operate the
window again as soon as the operating mechanism has cooled down.
After disconnecting the vehicle battery, automatic opening/closing of the win-
dow can be deactivated. In this case, the system must be activated as follows.
Activating window operation
›
Switch on the ignition.
›
Pull the top edge of the button and close the window.
›
Release the button.
›
Pull up the respective button and hold for 1 second.
Lights and visibility
Light
Introduction
Unless otherwise stated, the lights only work when the ignition is switched on.
For the basic position of the light switch, use position .
Note
The headlights may mist up temporarily. When the light is on, the light-emit-
ting surface demists after a short time.
Operating the lights
Fig. 53
Light switch and control dial for
headlight range adjustment
Toswitch the lights on/off,turn the
A
» Fig. 53 switch to one of the following
positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching the light on/off automatically » page 62
Switching on the parking lights or parking lights on both sides » page 64
Switch on low beam
Depending on the vehicle load, adjust the headlight range by turning the con-
troller
B
» Fig. 53 to the following positions.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
60
Using the system
Loading ...
Loading ...
Loading ...