Loading ...
Loading ...
Loading ...
8.1.3 Congure Other Parameters
Aer adding the access control device, you can set its parameters such as network parameters,
capture parameters, RS-485 parameters, Wiegand parameters, etc.
Set Network Parameters
Aer adding the access control device, you can set the device log uploading mode, and create
EHome account via wired or wireless network.
Set Log Uploading Mode
You can set the mode for uploading logs via EHome protocol.
Perform this task when you need to set the access control device's log uploading mode.
Steps
1.
Click Access Control → Device Management to enter the Device Management page.
2.
Select the device in the device list and click Modify.
3.
Click Network Sengs → Uploading Mode to enter the Uploading Mode page.
4.
Select the center group from the drop-down list.
5.
Check Enable to enable to set the oploading mode.
6.
Select the uploading mode from the drop-down list.
-
Enable N1 or G1 for the main channel and the backup channel.
-
Select Close to disable the main channel or the backup channel
Note
●
The main channel and the backup channel cannot enable N1 or G1 at the same me.
●
N1 refers to wired network and G1 refers to GPRS.
●
Only device with 3G/4G funcon supports seng the channel as G1.
●
For wired network sengs, see Create EHome Account in Wire Communicaon Mode .
●
For wireless network sengs, see Create EHome Account in Wireless Communicaon Mode .
7.
Click Save.
Create EHome Account in Wire Communicaon Mode
You can set the account for EHome protocol in wire communicaon mode. Then you can add
devices via EHome protocol.
Perform this task when you need to create EHome account in wire communicaon mode for access
control device.
Access Controller User Manual
54
Loading ...
Loading ...
Loading ...