Loading ...
Loading ...
Loading ...
Note
You can import all the channels of the device to the corresponding group by default.
8.
Oponal: Add the oine devices.
1) Check Add Oine Device.
2) Input the required informaon, including the device channel number and alarm input
number.
3) Click Add.
When the oine device comes online, the soware will connect it automacally.
9.
Click Add to add the device.
Add Devices by IP Segment
If you want to add devices of which the IP addresses are within an IP segment, you can specify the
start IP address and end IP address, user name, password, and other parameters to add them.
Perform this task when you need to add devices to the client by IP segment.
Steps
1.
Enter the Device Management module.
2.
Click Device tab and select Hikvision Device as the device type.
3.
Click Add to open the Add window.
4.
Select IP Segment as the adding mode.
5.
Input the required informaon.
Start IP
Input a start IP address.
End IP
Input an end IP address in the same network segment with the start IP.
Port
Input the device port No. The default value is 8000.
User Name
By default, the user name is admin.
Password
Input the device password.
Cauon
The password strength of the device can be automacally checked. We highly recommend
you change the password of your own choosing (using a minimum of 8 characters, including
at least three kinds of following categories: upper case leers, lower case leers, numbers,
Access Controller User Manual
49
Loading ...
Loading ...
Loading ...