Loading ...
Loading ...
Loading ...
Measurement Category Area
Measurement Parameter Area
In the measurement parameter interface, rotate the multifunction knob to
select a measurement item and then press down the knob to select it. Then the
measurement results of the item are displayed at the bottom of the screen
(measurement results of up to 10 items can be displayed at most). When you add a
new measurement item, its measurement result will be displayed as the first, with
the original items moving right in sequence. When you add a new measurement
item after ten items have been added, the last item at the bottom of the screen will
be closed. You can also enable the touch screen to tap the specified measurement
category and measurement item.
TIP
- When you rotate the multifunction knob to switch between the measurement parameter
area and the measurement category, you need to press down the knob to select the
desired measurement category.
- In the measurement category area, rotate the multifunction knob to select "Analyze".
The following figure is displayed. Select "Counter", "DVM", "Histogram", "Power"
(required to install the option MSO8000-PWR), "Eye", or "Jitter" (required to install the
option MSO8000-JITTER when "Eye" or "Jitter" is selected) to open the specified menu.
For description about these functions, refer to relevant chapters.
2. Source Selection
For different measurement categories, the selection methods for measurement
sources are different.
- Horizontal and vertical parameter measurement
Press > Add > Source A, then rotate the multifunction knob to select
the desired channel for measurement and press down the knob to select it. You
can also press Source A continuously or enable the touch screen to select it.
The available channels include CH1-CH4, Math1-Math4, and D0-D15.
Operations and Measurements
182
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Loading ...
Loading ...
Loading ...