Owner's Manual - Page 57

For Outlander PHEV 2016.

Loading ...
Loading ...
Loading ...
WARNING
l
Do not use the MITSUBISHI Remote
Control if children, persons in need of
care, pets, etc. are in the vehicle. Even if
the remote climate control is used, the
cabin may become hot or cold due to some
reasons such as automatic stop of the sys-
tem. The cabin temperature may quickly
rise in sunshine, which poses a risk of heat
stroke and dehydration. In cold weather,
on the other hand, the cabin temperature
may quickly drop. Either of which could
lead to death in the worst case.
l
The cooling fan in the engine compart-
ment may operate automatically when
charging or when operating air condition-
er. Do not bring your hand close to the
cooling fan during charging.
CAUTION
l
Do not use a car cover except for the
MITSUBISHI MOTORS GENUINE car
cover, when using the timer charging or the
remote climate control.
NOTE
l
Keep the following points in mind when us-
ing a wireless LAN device:
NOTE
•
Communication speed and range vary de-
pending on the wireless LAN devices and
the surrounding conditions (radio environ-
ment, obstacles, parking area environ-
ment, etc.).
•
Due to the characteristics of radio waves,
communication speed tends to decrease as
the communication distance increases.
Use your wireless LAN device at a short
distance from the vehicle for better re-
sponse.
•
When a microwave oven or ISM (indus-
trial, scientific and medical) equipment is
being used, the communication speed and
range of wireless LAN devices may de-
crease. Use your wireless LAN device
away from these appliances and equip-
ment.
•
If a wireless LAN device and Bluetooth
(registered trademark of Bluetooth SIG,
Inc.) are used simultaneously, the com-
munication speed and range of each de-
vice may decrease. Use your wireless
LAN device away from Bluetooth devi-
ces.
l
Wireless LAN devices may not communi-
cate with the vehicle, or may not operate
normally or stably in the following environ-
ment or situations. Check that the device can
communicate with your vehicle before use.
•
There is an obstruction such as a concrete
or metal wall between the vehicle and
wireless LAN device.
NOTE
•
The vehicle is surrounded by tall vehicles
in a parking lot.
•
There are facilities nearby that emit strong
radio waves, such as a TV tower, trans-
former substation, broadcasting station or
airport.
•
There is a communication device such as
a mobile phone or radio, or an electric de-
vice such as a personal computer near the
wireless LAN device.
•
The wireless LAN device is in contact
with or covered by a metal object.
•
The battery of the wireless LAN device
has run down.
l
The MITSUBISHI Remote Control cannot
be used under the following conditions:
•
The wireless LAN device is turned off.
•
The MITSUBISHI Remote Control appli-
cation software is not installed.
•
The MITSUBISHI Remote Control appli-
cation software is not running.
•
The wireless LAN device is not registered
on the vehicle or it is not connected to the
vehicle.
•
The wireless LAN device is out of the
communication range.
•
The wireless LAN device is connected to
other wireless LAN device.
•
The wireless LAN device has failed, or its
battery has run out.
MITSUBISHI Remote Control*
3-25
OGGE16E1
Charging
3
Loading ...
Loading ...
Loading ...