Loading ...
Loading ...
Loading ...
CAUTION
l
The Ultrasonic misacceleration Mitigation System does not operate in the following conditions:
•
The operation mode is other than ON.
•
The Ultrasonic misacceleration Mitigation System is set to OFF by operating the Forward collision mitigation system (FCM) and Ultrasonic misaccelera-
tion Mitigation System ON/OFF switch.
•
The select position is in the “P” or “N” position.
•
The ASC is set to OFF by operating the ““ASC OFF” switch” on page 7-33.
l
It sometimes happens that a motorcycle, bicycle or pedestrian are detected as obstacles, but these are not the object of the Ultrasonic misacceleration Mitiga-
tion System operation.
l
The Ultrasonic misacceleration Mitigation System may not operate in the following conditions.
•
When driving in the place which the outside temperature changes suddenly (tunnel or garage etc.).
•
Under adverse weather conditions (rain, strong winds, snow, sand storms, etc.).
•
When approaching an obstacle too closely.
•
When a vehicle cuts in front or behind your vehicle very closely.
•
When your vehicle changed the course and approached immediately behind an obstacle.
•
When only a part of the obstacle is within the detection areas of the sensor.
•
When the rain, snow, water or dirt adheres to the sensor.
•
When the sensor is extremely hot or cold (while the vehicle is parked for a long period of time under a blazing sun or in cold weather).
•
Immediately after Plug-in Hybrid EV System starting.
•
When driving on a road with many and successive curves, including when passing their entrances and outlets.
•
When you are driving on a road with steep and alternating up and down slopes.
•
When a road surface is surging, and there is unevenness.
•
When the system judges driver’s steering or gear shifting actions as evasive actions to avoid collision.
•
For a short period after the system judges the repeated depression of the accelerator pedal at a few seconds interval as a release operation.
•
When the vehicle body is extremely inclined by carrying heavy loads or improper adjustment of the tyre pressure.
•
When the driving is unstable due to an accident or trouble.
•
The system receives ultrasonic noise from other sources (the horns of other vehicles, motorcycle engines, brakes, radios, pouring rain, splashing water,
snow traction device (tyre chains), etc.).
•
Obstacle is not vertical to the ground, the obstacle is not at right angles to vehicle traveling direction, or when there is uneven walls and wavy walls.
•
The sensors or surroundings have been wiped by hand, or stickers or accessories have been attached.
Ultrasonic misacceleration Mitigation System*
7-65
OGGE16E1
Starting and driving
7
Loading ...
Loading ...
Loading ...