Loading ...
Loading ...
Loading ...
Fluid type
Use brake fluid conforming to DOT3 or
DOT4 from a sealed container. The brake
fluid is hygroscopic. Too much moisture in
the brake fluid will adversely affect the brake
system, reducing the performance.
CAUTION
l
Take care in handling brake fluid as it is
harmful to the eyes, may irritate your skin
and also damage painted surfaces.
l
Use only the specified brake fluid.
Do not mix or add different brands of brake
fluid to prevent chemical reactions.
Do not let any petroleum-based fluid touch,
mix with, or get into the brake fluid.
This will damage the seals.
l
Keep the reservoir tank cap closed to pre-
vent the brake fluid from deteriorating ex-
cept maintenance.
l
Clean the filler cap before removing and
close the cap securely after maintenance.
Auxiliary battery
E01001203343
The condition of the auxiliary battery is very
important for quick starting of the plug-in hy-
brid EV system and proper functioning of the
vehicle’s electrical system. Regular inspec-
tion is especially important in cold weather.
Be sure to have a MITSUBISHI MOTORS
Authorized Service Point check the auxiliary
battery.
WARNING
l
Be sure to have a MITSUBISHI
MOTORS Authorized Service Point
charge the battery. Do not charge the bat-
tery yourself. Flammable gases may leak
and explode.
CAUTION
l
There is a type of auxiliary battery is not
properly installed in the vehicle, even if the
same specification.
When replacing the auxiliary battery, please
contact a MITSUBISHI MOTORS Author-
ized Service Point.
NOTE
l
When the auxiliary battery is removed, the
controlling timer for forcibly starting the en-
gine may be reset.
Since a fuel injection device may cause a
clogging if the state where the engine does
not operate continues after reset of the timer,
please press the battery charge switch in or-
der to start the engine. However, when the
drive battery is near full charge, even if the
battery charge switch is pressed, the engine
may not start. In that case, press the battery
charge switch again after the drive battery
quantity decreases. Refer to “Battery charge
switch” on page 7-22.
l
When the auxiliary battery is removed, since
the timer control of the MITSUBISHI Re-
mote Control is reset and the drive battery
temperature control can not be used, com-
municate the wireless LAN device and your
vehicle again.
l
When the auxiliary battery is removed, the
timer control of the MITSUBISHI Remote
Control is reset and each function of the
MITSUBISHI Remote Control can not be
used. Also the drive battery can not be
warmed up.
Communicate the wireless LAN device and
your vehicle again.
Auxiliary battery
11-09
OGGE16E1
Maintenance
11
Loading ...
Loading ...
Loading ...