Loading ...
Loading ...
Loading ...
1. Get the vehicles close enough so the
jumper cables can reach, but be sure the
vehicles aren’t touching each other.
2. Turn off all lamps, heater and other elec-
trical loads.
3. Set the parking brake firmly on each ve-
hicle. Set the gear of another vehicle in
“P” (PARK) position (with A/T) or in
“N” (Neutral) position (with M/T) and
stop the engine.
WARNING
l
When connecting the jumper cable, stop
the engine in the other vehicle. Otherwise,
the cables or your clothes may be caught
by the fan or drive belt and personal in-
jury could result.
l
The cooling fan turns on and off depend-
ing on the coolant temperature. Do not
bring your hands close to the fan while
the engine is running or the Plug-in Hy-
brid EV System is operating.
4. Open the bonnet, remove the fuse cover
of the main fuse block.
Refer to “Bonnet” on page 11-04 and
“Fuses: Engine compartment” on page
11-17.
5. Open the cover of the jumper cable ter-
minal in the main fuse block.
NOTE
l
You cannot rescue another vehicle’s dis-
charged battery by connecting jumper cables
while using this jumper cable terminal.
6. Connect one end of one jumper cable
to the jumper cable terminal (A) of your
vehicle, and the other end to the posi-
tive (+) terminal of the booster battery
(B).
Connect one end of the other jumper ca-
ble
to the negative (-) terminal of the
booster battery, and the other end to
the designated ground location of your
vehicle.
WARNING
l
When connecting the jumper cables, do
not connect the positive (+) cable to the
negative (-) terminal. Otherwise sparks
might cause explosion of the battery.
Emergency starting
9-03
OGGE16E1
For emergencies
9
Loading ...
Loading ...
Loading ...