Owner's Manual - Page 272

For Outlander PHEV 2016.

Loading ...
Loading ...
Loading ...
CAUTION
When the vehicle is leaning much to one
side due to heavy luggage on it or improp-
erly adjusted tyre pressures.
When oncoming vehicles’ headlamps
shine the LDW camera.
When the vehicle is equipped with non-
standard tyres (including excessively
worn tyres), is using a snow traction de-
vice (tyre chains), or has non-specified
components such as a modified suspen-
sion.
When the windscreen is covered with rain
water, snow, dust, etc.
l
Follow the instructions given below to keep
your LDW in good operating conditions.
Always keep the windscreen clean.
Avoid applying a strong shock or pressure
to the LDW camera. Do not attempt to
disassemble it.
Disturbing the installation of the LDW
camera or its removal is under no circum-
stances permitted. The camera has been
precisely oriented at the factory.
Do not put anything like a sticker on the
area in front of the LDW camera lens of
the windscreen.
Use only MITSUBISHI MOTORS GEN-
UINE Parts when replacing the wind-
screen wipers.
Tyre pressure monitoring
system (TPMS)
E00637100110
The tyre pressure monitoring system (TPMS)
uses tyre inflation pressure sensors (A) on the
wheels to monitor the tyre inflation pressures.
The system only indicates when a tyre is sig-
nificantly under-inflated.
The base tyre pressure can be set at desired
value by the driver with the reset function ex-
ecution. (The low pressure warning threshold
is set based on the reset.)
The tyre inflation pressure sensor IDs for two
sets of tyres can be registered by a
MITSUBISHI MOTORS Authorized Service
Point, and the valid ID set can be switched by
the multi-information display switch. (It’s
beneficial in case of seasonal tyre change be-
tween summer tyre and winter tyre.)
NOTE
l
The tyre pressure monitoring system
(TPMS) is not a substitute for regularly
checking tyre inflation pressures.
Be sure to check the tyre inflation pressures
as described in “Tyres” on page 11-10.
l
The tyre inflation pressure sensor (B) is in-
stalled in the illustrated location.
Replace grommet and washer (C) with a
new one when the tyre is replaced.
For details, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Tyre pressure monitoring sys-
tem warning lamp/display
E00637200078
Tyre pressure monitoring system (TPMS)
7-72
OGGE16E1
Starting and driving
7
Loading ...
Loading ...
Loading ...